Satel INTEGRA Especificaciones descargar pdf (Pagina 32)

30 INTEGRA 128-WRL SATEL

zones outputs

It. list of devices

no device No device

1 ASP-105 siren 9 ASP-105 siren 9 ASP-105 siren

2 ^ 10 ASP-105 siren 10 ASP-105 siren

3 APD-100 detector 11 APD-100 detector 11

unused/unavailable

4 APD-100 detector 12 APD-100 detector 12

unused/unavailable

5 AMD-100 detector 13 AMD-100 detector 13

unused/unavailable

6 AMD-100 detector 14 AMD-100 detector 14

unused/unavailable

7 AMD-101 detector 15 AMD-101 detector 15

unused/unavailable

8 ^

16 AMD-101 detector 16

unused/unavailable

Table 5. Example of how to properly register wireless devices. The system has reserved

8 zones and 8 outputs for devices occupying 8 items.

3.14.1 Adding new wireless devices

3.14.1.1 DLOADX program

1. Open the STRUCTURE window, click your mouse on the Hardware TAB, and then on

the WIRELESS SYSTEM branch.

2. Click your mouse on the NEW DEVICE button. The NEW DEVICE window will open.

3. Enter the 7-digit serial number of the device being added. The serial number can be

found on the electronics board or on the housing. Each ARF-100 tester of radio

signal level has serial number 0000500.

4. Depending on which device is to be added to the system:

− switch on power supply of the ACX-200 or ACX-201 expander,

− switch on the ARF-100 tester,

− insert the ASW-100 E/ASW-100 F wireless controller into 230 V socket,

− insert battery into the ASD-100 detectors,

− violate (open) the tamper contact in case of the other devices.

If a wrong serial number is entered, a corresponding message will be displayed.

In such a case, enter the correct serial number and repeat the above-mentioned

operation.

5. A message will confirm that a new device has been added. Click your mouse on the

"OK" button to finish the new device adding procedure. You can cancel the new

device adding procedure by pressing the "Cancel" button. You can also immediately

proceed to adding a next wireless device by pressing the "Next" button.

Note: After completion of the procedure of adding new wireless devices to the system,

start the expander identification function.

3.14.1.2 LCD keypad

1. Start the NEW DEVICE function (SERVICE MODE ÆSTRUCTURE ÆHARDWARE

ÆEXPANDERS ÆSETTINGS ÆABAX - MAINBOARD ÆNEW DEVICE).

2. Enter the 7-digit serial number of the device and press the [#] key. The serial number

can be found on the electronics board or on the housing. Each tester of radio signal

level has serial number 0000500.

If the device with the entered serial number has already been registered, the keypad

will signal it by 3 long beeps and will not proceed to the next step of the procedure.

3. Expander identification will be performed automatically (a corresponding message

will inform you about it).

4. When the "Open device tamper" message is displayed on the keypad:

− switch on power supply of the ACX-200 or ACX-201 expander,

1 2 ... 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios

Satel INTEGRA Especificaciones Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Monóxido de carbono (co) detectores Satel INTEGRA