Satel INTEGRA Especificaciones descargar pdf (Pagina 12)

10 INTEGRA 128-WRL SATEL

regard to hardwired devices (connection of keypads, expansion modules,

detectors, sirens, etc.).

The control panel should be installed indoors, in spaces with normal humidity of air.

The control panel must be protected against unauthorized access.

Installation place of the control panel should be selected so that all the wireless devices

which are to be controlled by it, are indeed within its operating range. It is recommended that

the panel be installed at a high location. This will enable a better radio communication range

to be achieved, while avoiding the risk of the control panel being accidentally covered by

people moving around the site.

A permanent (not disconnectable) 230 V AC power supply circuit with protective grounding

must be available at the control panel installation place.

Explanations for Figure 2:

1 - battery connection cables (red +, black -).

2 - LED indicator of OUT1 high-current output status.

3 - LED indicator of OUT2 high-current output status.

4 - pins for setting battery charging current:

− pins shorted (jumper on) – 400 mA

− pins open (no jumper) – 800 mA

5 - CHARGE LED. Indicates battery charging.

6 - port RS-232. It allows local programming and management of the system by means of

DLOADX or GUARDX program (the cable for making connection RJ type socket on the

control panel mainboard and the DB9 socket on the computer is supplied by SATEL).

Enables remote programming by means of DLOADX program through Ethernet (TCP/IP)

network, if the ETHM-1 module is connected. Makes interfacing possible with an

external analog or ISDN modem.

7 - STTS LED. Indicates operation status of the supervision circuit of wireless devices.

8 - MEMORY pins. Never remove jumper from these pins. Removal of the jumper

results in disconnection of the battery backup for the clock and RAM memory and,

consequently, in loss of the clock settings and all data stored in the RAM memory.

9 - RESET pins. In case of emergency, they make it possible to start the STARTER

program, local computer programming function or service mode (see: P

ROGRAMMING

manual).

10 - SIM card socket. It is not recommended to insert the SIM card into its socket before the

card PIN code has been programmed in the control panel.

11 - socket to connect antenna for communication with wireless devices.

12 - GSM STATUS LED. Indicates GSM network status:

− LED off – telephone not working,

− LED blinking at short intervals – telephone has failed to find network,

− LED blinking at long intervals – telephone has found network,

− LED blinking at very short intervals – GPRS communication.

13 - OUT3...OUT8 LEDs. Indicate status of OUT3...OUT8 low-current outputs.

14 - GSM telephone.

15 - socket for voice synthesizer.

16 - socket for GSM/GPRS communication antenna.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Comentarios a estos manuales

Sin comentarios

Satel INTEGRA Especificaciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Monóxido de carbono (co) detectores Satel INTEGRA