Satel INTEGRA Manual de usuario descargar pdf (Pagina 9)

INTEGRA SATEL

card arm/disarm devices, partition keypads, code locks, as well as proximity card / DALLAS

chip readers.

The LCD keypads and proximity card arm/disarm devices INT-CR may be used to control

many partitions in various objects. The partition keypads control just one partition. Individual

control devices are assigned by the installer to specified partitions. The users may operate

the control panel only if they have access to partitions operated by particular keypads. This

means that the partitions assigned to the user at the stage of creating/editing a new user (see

DESCRIPTION OF USER FUNCTIONS ÆUSERS) must correspond to those operated by the

keypad. The list of partitions operated by LCD keypad or proximity card arm/disarm device

INT-CR is defined by the installer.

Example: LCD keypad controls partitions 1,2,3,4,5 and 6. The user has access to partitions

5,6,7 and 8. Hence, using this LCD keypad he can control partitions 5 and 6.

A similar principle applies to partition keypads, code locks, proximity card readers and

DALLAS chip readers. With keypads, the user can control the partitions he has access to,

and he may open the doors with code locks and proximity card/DALLAS chip readers, to

opening of which he has been authorized. The installer defines the list of users of individual

partition keypads, code locks and readers (separately for each module).

The access to the control panel control functions and the vital information on the system

status are protected with a CODE (the code is a combination of 4 to 8 digits). In systems

which require enhanced protection, it is possible to extend the code by a prefix (1 to 8 digits),

periodically changed by the object master user code.

The installer can allow some functions to be run in the keypad without entering the code

PROG. Press and hold down the keys below for 3 seconds to:

[1] – view zones status,

[4] – view partitions status,

[5] – view alarms log,

[6] – view troubles memory,

[7] – view current troubles,

[8] – switch on/off chime signal in LCD keypad,

[9] – toggle the display between standby mode and partitions state presentation mode,

X or W – view messages about partition alarms (use the same keys to scroll through the

list of messages),

S or T – view messages about zone alarms (use the same keys to scroll through the list of

messages),

– trigger the auxiliary alarm (for example, calling for medical aid),,

– trigger the fire alarm,

– trigger the panic alarm. The installer can determine whether the triggered panic

alarm will be an audible one (initiating the alarm signaling), or a silent one (with

no signaling).

It is recommended that the above way of calling functions be only available in

LCD keypads which are not accessible to unauthorized personnel.

If the installer has allowed for the quick arming option, the armed mode can be enabled

without entering any code, by pressing in turn the following keys:

− [0] and [#] – fully armed;

− [1] and [#] – fully armed plus zone bypasses with BYPASSED IF NO EXIT option enabled;

− [2] and [#] – armed without interior;

− [3] and [#] – armed without interior and without entry delay.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 74 75

Comentarios a estos manuales

Sin comentarios

Satel INTEGRA Manual de usuario Pagina 9

Comentarios a estos manuales