Satel INTEGRA Manual de usuario descargar pdf (Pagina 13)

INTEGRA SATEL

- GROUP (two green LEDs) – used in graphic mode functions to indicate which data set is

currently displayed. The LEDs can show the number of zones or outputs, or indicate

the corresponding expander bus. (See: section SELECTION FROM THE MULTIPLE-CHOICE

LIST IN THE GRAPHIC MODE

LED

INDICATION

left side/upper right side/lower

DESCRIPTION

OFF OFF group 1; numbers 1–32 (n)

OFF ON group 2; numbers 33–64 (32+n)

ON OFF group 3; numbers 65–96 (64+n)

ZONES/

OUTPUTS

ON ON group 4; numbers 97–128 (96+n)

OFF OFF

first expander bus

bus 1 numbers (addresses) 0-31 (DEC)

system addresses 00–1F (HEX)

EXPANDER

BUSES

OFF ON

second expander bus

bus 2 numbers (addresses 0-31 (DEC)

system addresses 20–3F (HEX)

n – number of LCD keypad field

6.1.2 Audible signals in keypads

When using the keypad the following signals, characteristic of some situations, can be heard

PROG.

• One long beep – refusal of arming - the zone, which shouldn't be violated at the time of

arming, is violated (PRIORITY option), there was a trouble with the battery, expander, or

keypad. The refusal includes all zones selected for arming. Also, warning of the system

failure - prior to arming.

• Two long beeps – unknown code/card, exit function/menu, or unavailable function.

• Three long beeps – the code is recognized, but the function called is not accessible

(for example, temporary partition blocking is activated or the user has no access to

partitions operated from the keypad).

• Two short beeps – selection accepted – entering more detailed menu level.

• Three short beeps – acknowledgement of arming or disarming.

• Four short and one long beeps – acceptance of execution of the selected function.

• Three pairs of short beeps – it is necessary to change the code (for example, another

user, when changing his code, indicated the combination of digits identical with that in the

given user code; the code validity is expiring).

Additionally, the following situations may be signaled:

• Alarm in partition – continuous beep.

• Fire alarm – long beep every second.

• Countdown of entry delay – 2 short beeps every second.

Note: The signaling of entry delay countdown by 2 short beeps refers to the LCD keypads

type INT-KLCD-GR/BL and INT-KLCDR-GR/BL with firmware in version 1.05, and to

the keypads type INT-KLCDL-GR/BL, INT-KLCDS-GR/BL and INT-KLCDK-GR with

firmware in version 6.05. In keypads with earlier firmware versions, the entry delay

countdown is signaled by short beeps every 3 seconds.

• Countdown of exit delay – long beeps every 3 seconds, completed with a series of

short beeps (for 10 seconds) and a single long beep. The way of “exit delay" signaling

informs that the countdown is ending prior to arming.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 74 75

Comentarios a estos manuales

Sin comentarios

Satel INTEGRA Manual de usuario Pagina 13

Comentarios a estos manuales