Satel INTEGRA Manual de usuario descargar pdf (Pagina 15)

INTEGRA SATEL

51 Selected events

52 All events

6 Set time

7 Troubles

8 Outputs control

9 Service mode

0 Downloading

01 Start DWNL-RS

02 Finish DWNL-RS

03 Start DWNL-MOD.

04 Start DWNL-TEL

05 Start DWNL-CSD [only INTEGRA 128-WRL]

06 Start DWNL-GPRS [only INTEGRA 128-WRL]

07 ETHM-1 – DloadX

08 ETHM-1 – GuardX

Note: The shortcuts in the DOWNLOADING menu are available when the control panel

configuration and settings make it possible to use the selected function.

The installer can assign functions to the arrow keys to facilitate the everyday operation of

the system. These functions are called in the following way:

[CODE] S

[CODE] W

[CODE] X

[CODE] T

One of the following functions can be assigned to each arrow:

− Arming (full)

− Arming (without interior zones)

− Arming (without interior zones, without entry delay)

− Disarming

− Alarm clearing

− Zones bypassing (inhibit)

− Bypass clearing

− Output MONO ON

− Output BI switch state

− Output BI ON

− Output BI OFF

− Arming (full+bypasses)

For each of the functions the installer determines the number of partition, zone or output it

refers to. The user, who wants to perform the given function must have an appropriate

authority level and access to the selected partitions.

All user functions, which are accessible from LCD keypad, are described in section

ESCRIPTION OF USER FUNCTIONS.

6.1.4 Entering data by means of the LCD keypad

The ways of data entering can differ, depending on the function and the type of data. In most

cases, the data are saved on pressing the [#] or [ok] key. Some functions require acceptance

of the entered data by pressing an additional key (the control panel can be configured by the

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 74 75

Comentarios a estos manuales

Sin comentarios

Satel INTEGRA Manual de usuario Pagina 15

Comentarios a estos manuales