Satel INTEGRA Manual de usuario descargar pdf (Pagina 17)

INTEGRA SATEL

Key Characters available after next keystroke

1 ! ? ' `  " { } $ % & @ \ ^ |

# 1

2 a b c 2

3 d e f 3

4 g h i 4

5 j k l 5

6 m n o 6

7 p q r s 7

8 t u v

9 w x y z 9

0 . , : ; + -

/ = _ < > ( ) [ ] 0

Table 1. Characters available when entering names. The lower case letters are available

under the same keys (to change the letter case, press T key).

Shown on the left side in the upper line of the display is information about the letter case:

[ABC] or [abc] (it will be displayed after pressing any key and will be visible for a few seconds

after the last keystroke).

The X key moves the cursor to the right, and the W key – to the left. The S key deletes the

character on the left side of the cursor.

6.1.5 Reading alarm source name

The installer can enable the function of displaying the name of alarm source on the LCD

keypad, without necessity of entering the code. In such a case, the partition or zone name is

displayed on the keypad screen when an alarm occurs. If there are a few alarm causes, you

may scroll through the zone names which caused the alarm, and the names of partitions

where the alarm is (or was) signaled. The W and X arrow keys allow viewing partition names

(if the alarm occurred in several partitions), while the S and T keys allow viewing the names

of zones which caused the alarm. These names (entered by the installer) are displayed

cyclically in the lower keypad screen line, in the order corresponding to the numbers of

zones/partitions in the system. To view the names of alarm sources when the alarm signaling

is over, press and hold down the corresponding arrow key.

6.1.6 Proximity card reader (INT-KLCDR-GR/INT-KLCDR-BL only)

The INT-KLCDR-GR/INT-KLCDR-BL keypads with built-in proximity card reader make

available a few extra functions, including:

• card code readout when the card is assigned to its user (functions: NEW USER, EDIT USER),

• performance of function specified by the installer,

• registering the guard round.

The keypad can respond to the card being briefly presented to the reader or to its being

presented and held for a few seconds (approx. 3 sec.). It is also possible to perform two

consecutive functions which are assigned to bringing the card closer and holding it at the

reader. This feature makes it possible, by a single use of the card, to perform rather

complicated functions which might be time-consuming when called from the keypad.

List of functions which can be called by using the proximity card:

1. no function – no response

2. as code

– enters the user functions menu

3. as code # – calls the function of selecting partitions to be armed or disarmed

(arming/disarming if the selection list for the particular code is limited to just one partition)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 74 75

Comentarios a estos manuales

Sin comentarios

Satel INTEGRA Manual de usuario Pagina 17

Comentarios a estos manuales