
SATELLINE-EASy Pro
User Guide v.1.5
70
In case you need more information on the time delays related to the use of SL-commands, please
contact the manufacturer.
In order to get information of the latest and/or special SL-commands please contact SATEL Oy.
9.4.1 Frequency
Effect and description of command
Set RX-frequency to nnn.nnnnn MHz
Set TX-frequency to nnn.nnnnn MHz
Set both RX&TX-frequency to same nnn.nnnnn MHz
Get RX- frequency (response 'nnn.nnnnn MHz')
Get TX- frequency (response 'nnn.nnnnn MHz')
Get RX&TX- frequencies (response TX nnn.nnnnn MHz, RX nnn.nnnnn MHz)
Get Reference (Center) frequency (response 'nnn.nnnnn MHz')
Set Reference (Center) frequency to nnn.nnnnn MHz
Set RX&TX- frequency nn channels above reference frequency
Frequency = Reference frequency + nn * Channel spacing, where nn=[0...Number of
channels/2]
Set RX&TX- frequency nn channels below reference frequency
Frequency = Reference frequency – nn * Channel spacing, where nn=[0…Number of
channels/2]
Get current RX&TX- frequency deviation from reference frequency as channels
(Frequency – Center frequency)/Channel spacing (response ‘+nn’ or ‘-nn’)
Get channel spacing (response ‘nn.n kHz’)
Set operational mode of the radio. The different values of x are:
”S” = Single Channel
”D” = Dual Channel
”R” = Reverse Dual Channel
Note! Use this command only, if the setup of the frequency bands matches the Dual
Channel operation.
Get operational mode of the radio. The response is one of the following:
”S” = Single Channel
”D” = Dual Channel
”R” = Reverse Dual Channel
Note! Use this command only, if the setup of the frequency bands matches the Dual
Channel operation.
Comentarios a estos manuales