Satel INTEGRA Plus Manual de usuario descargar pdf (Pagina 43)

SATEL INTEGRA Plus 41

8.1.3 Sound signaling

Beeps generated when operating

The installer can disable the sound signaling or replace it by blinking of the keypad

backlight.

1 short beep – pressing any digit key or confirmation that code has been entered.

4 short and 1 long beeps – confirmation of door unlocking or execution of another function.

2 long beeps – unknown code/card.

3 long beeps – unavailable function.

Events signaled by sounds

Only installer selected events are signaled.

5 short beeps – zone violation (CHIME).

Very short beeps – door open too long.

8.2 Functions available from code lock

Depending on the user type and authority level, as well as the code lock settings, entering

the code and confirming it with the or key will result in:

– unlocking the door (activating the relay);

– changing over the status of 25. BI SWITCH type outputs;

– turning on the 24. MONO SWITCH type outputs;

– guard round confirmation;

– enabling temporary partition blocking.

The installer can permit triggering alarms from the keypad. To trigger an alarm, do the

following:

fire alarm – press the (INT-SZ) / (INT-SZK) key for approx. 3 seconds;

medical (auxiliary) alarm – press the 0 key for approx. 3 seconds;

panic alarm – press the

(INT-SZ) / (INT-SZK) key for approx. 3 seconds. The

installer defines whether the triggered alarm will be loud (setting off the loud alarm

signaling) or silent (without loud signaling).

The installer can permit changing own code by means of the code lock. Proceed in the same

way, as when changing the code by means of the partition keypad (see: p. 38).

9. Confirming voice messaging

The installer can configure the control panel so that confirmation of listening to the voice

message be required. If there is no confirmation, the control panel can connect many times

for playback of the message. Having listened to the message can be confirmed from the

keypad of DTMF dialing telephone. The installer defines whether any 4-digit sequence is

sufficient to confirm receipt of a voice message, or it must be a specific code. After entering

of the code, the control panel will give the following information by means of sound signals:

1 short beep repeated every 3 seconds – the message has been confirmed, wait for

playback of the next voice message;

4 short and 1 long beeps – the message has been confirmed, there are no more voice

messages;

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Sin comentarios

Satel INTEGRA Plus Manual de usuario Pagina 43