Satel INTEGRA Plus Manual de usuario descargar pdf (Pagina 11)

SATEL INTEGRA Plus 9

8 - enable/disable chime signal in the keypad;

9 - toggle the display between the standby mode and partition state display mode.

The other keys enable you to:

- enter the user menu (after entering the code);

- cancel the started operation.

or - arm / disarm and clear alarm (after entering the code);

- start the selected function;

- confirm the entered data.

    - navigate through the display (scroll through the displayed messages, functions

and options, and move the cursor);

- run the installer selected functions (after entering the code).

- trigger the fire alarm.

- trigger the medical (auxiliary) alarm.

- trigger the panic alarm.

5.1.4 Built-in proximity card reader

The INT-KLCDR keypad can be operated by means of proximity cards (proximity tags or

other 125 kHz passive transponders). The installer defines which functions can be executed

after presenting or holding the card.

5.1.5 Sound signaling

Beeps generated when operating

The installer can disable the sound signaling.

1 short beep – pressing any number key.

2 short beeps – confirmation of command execution, signaling of entering the user menu,

submenu or function.

3 short beeps – signaling of:

– starting the arming procedure (if no exit delay has been programmed, this is equivalent

to arming),

– disarming and/or alarm clearing;

– turning output off;

– disabling chime signal in the keypad, using the 8 key;

– toggling the display between the standby mode and the partition status presentation

mode, using the 9 key;

– exiting the function and returning to the menu after confirmation of the data entered.

4 short beeps and 1 long beep – signaling of:

– turning output on;

– enabling chime signal in the keypad, using the 8 key;

– ending the function and exiting the user menu after confirmation of the data entered.

1 long beep – signaling of:

– violated/ bypassed zones when arming;

– fault of the vibration detector (10. 24H VIBRATION type zone was not violated during the

vibration detector test run upon starting the arming procedure).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Sin comentarios

Satel INTEGRA Plus Manual de usuario Pagina 11