Satel CA-10 Manual de usuario descargar pdf (Pagina 8)

USER MANUAL CA-10

States of control panel armed zones in LCD keypad

The LCD keypad can indicate in the bottom line of its display, either periodically or

permanently, the state of control panel armed zones. Given below are symbols which

may be displayed at the successive items (1–16) and their meaning.

 - zone free (not violated)

 - zone violated

S - violated tamper circuit of two-parameter zone

a - there was alarm from a zone (alarm memory)

s - there was tamper alarm from a two-parameter zone (tamper memory)

b - zone bypassed

These symbols may be changed with the service function of LCD keypad.

States signaled with sound

The signals produced to confirm the operation on the keypad

 three short - system arming/disarming confirmation, alarm clearing, deactivating

output type 13 (BI switch),

 two long - wrong access code, canceling a function or incorrect data for

a function,

 three long - an attempt to arm the system when the zones with PRIORITY option

are violated or tampered (see: Arming),

 four short, one long - correct user function completion, activating type 13 (BI

switch) output, or activating type 12 (MONO switch) output.

System events signaling

 continuous signal - alarm condition,

 intermittent signal - fire alarm,

 one short signal every 3 seconds – entry delay time (or service mode),

 one long signal every 3 seconds - exit delay time,

 two short signals every 3 seconds - trouble,

 five short - CHIME zone violated,

 five long - DAY/NIGHT zone violated when the partition is disarmed, or counting

zone violated when the partition is armed.

The installer determines which events and in which keypads are to be signaled

acoustically.

User Access Codes

For everyday operation of the system it is necessary to know the user access code. The

control panel comes with one factory-set code (master user code) for each partition:

1234 for partition 1 (A),

2345 for partition 2 (B),

3456 for partition 3 (C),

4567 for partition 4 (D).

Additional 12 user access codes may be programmed for each partition (but no more

than 32 for the entire system). The code can be 4 to 6 digits long.

http://www.ealarm.com.my

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

Comentarios a estos manuales

Sin comentarios

Satel CA-10 Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Satel CA-10