Satel CA10 plus - LCD keypad Programming and Installation Manual
- 2 -
Keypad description.
The keypad displays information on a 2-line LCD display (2x16 characters) with
backlight and six additional LED controls.
LED controls' functions:
•
ALARM
- signals occurrences of alarms.
•
TROUBLE
- blinks when the panel signals a hardware problem or telephone
communication trouble.
•
PARTITION 1
÷
PARTITION 4
- partition status signaling:
-
blinking (while the ALARM control is off) signals exit delay running.
-
control stays on when the partition is armed.
The function of LED controls changes after user or service mode is entered, according
to the principles of status communicating by LED keypads (c.f. "CA10 plus with LED
keypad user manual").
The keypad has 12 keys, labeled according to telephone data input standard. Additional
four arrow keys support MENU navigation and selecting functions. After a function has
been chosen, the arrow keys support programming. The keys
Õ
and
Ö
move the
cursor, the key
×
backspaces deleting the character that proceeds the cursor and the
key
Ø
toggles the data input mode (insert or overwrite).
Modes.
The keypad can function in one of the following three modes:
1.
Text mode
: the first line displays system date and time. The second line displays
system status messages, which can be standard (e.g. SYSTEM OK, ARMED etc.),
or defined by the installer (e.g. SERVICE 555-34-77 instead of SYSTEM
TROUBLE). In this mode it is possible display all current messages alternately or
according to priority. In priority mode only the highest priority message is displayed
(e.g. ALARM). In non-priority mode all relevant messages are displayed one after
another in a closed cycle (e.g. ALARM and ARMED by turns).
2.
Mixed mode, LCD standard
: the first line displays system date and time while in
the second line the status of all 16 zones is being monitored. The status of each
zone is displayed as a single character (e.g. [
*
] = zone OK, N = zone violated). After
a change in the system status (e.g. after arming the system) the keypad displays
the status as in the first mode and after a while turns to zone monitoring.
3.
Mixed mode, LED standard
: this mode is similar to the second one. The second
line is used to monitor the status of 12 zones as in the case of LED keypad.
Operating mode 1 or 2 is recommended for the LCD-S keypad. The user can
temporarily change the display mode, switching over between the text mode and the
zone state display by holding down the
Ø
key.
(20 paginas)
(27 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales